Use the best ways of preparing for HPE6-A45 Exam Dumps with LatestCram HP HPE6-A45 dump PDF [2021]
HP HPE6-A45 exam candidates will surely pass the Exam if they consider the HPE6-A45 dumps learning material presented by LatestCram.
NEW QUESTION 57
Refer to the exhibits.
Exhibit 1
Exhibit 2
Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes. The network administrator decides to enter this command on Switch-1:
Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120
Exhibit 2 shows the VRRP configuration just after the change. What is the effect of this change?
- A. Switch-1 now waits to take over as Master if it fails and recovers. This should prevent the connectivity issue from occurring again.
- B. Switch-1 experiences an internal error in the VRRP process. This error causes Switch-2 to take over as Master for VLAN 2.
- C. Switch-1 and Switch-2 both become Master in their own VRRP virtual router due to the delay timer mismatch. The mismatch must be fixed.
- D. Switch-1 continues to act as it did before the preempt delay time was set. Administrators must plan additional changes to fix the issue.
Answer: B
NEW QUESTION 58
Refer to the exhibit.
A network administrator wants to add the protections of root guard to the network. Based on the spanning tree topology, on which ports should the network administrator implement root guard?
- A. 3-24
- B. 1 and 2
- C. A1 and A2
- D. 2 and A3
Answer: C
NEW QUESTION 59
A network administrator configures VSF settings on two Aruba 2930F switches. The switches form two separate VSF fabrics. What should the administrator check?
- A. that the switch with the lower priority has the lower member ID
- B. that each switch is assigned a unique VSF priority
- C. that the domain ID matches on both switches
- D. that LLDP MAD is configured on both members
Answer: C
NEW QUESTION 60
A network administrator applies the ACL shown in the exhibit. Which source IP address does the myList ACL deny?
- A. 10.1.0.10
- B. 10.1.1.10
- C. 10.2.1.10
- D. 10.1.2.10
Answer: C
NEW QUESTION 61
Refer to the exhibits.
Exhibit 1
Exhibit 2
A company does not require authentication for security, but AOS-Switches are set up to use local MAC authentication (LMA) to assign the correct VLAN and priority to IP phones. IP phones and computers belong to different VLANs. Each device is supposed to connect to a specific port, but sometimes users connect their devices to the wrong ports and cannot receive access without help from IT.
How can a network administrator configure the switches to eliminate this issue?
- A. Add the MAC addresses for computers to the myPhones MAC group.
- B. Apply LMA to all edge switch ports, and set the unauth VLAN to the user VLAN.
- C. Create a user role that applies the user VLAN, and set this role as the initial role.
- D. Set the address limit to 2 on the switch ports that apply LMA.
Answer: A
NEW QUESTION 62
What is a typical reason to implement MAC authentication on an AOS-Switch?
- A. to control management access to the switch CLI based on device, as well as user credentials
- B. to filter traffic at the edge, based on multiple criteria in the MAC header
- C. to enhance the security of an 802.1X solution
- D. to provision switch ports to support devices such as IP phones or printers
Answer: C
NEW QUESTION 63
Refer to the exhibit.
A company wants to change Area 1 shown in the exhibit from a stub area to a totally stub area.
What will be one effect of this planned change?
- A. Endpoints within Area 1 will no longer be able to reach endpoints in other areas.
- B. Routing devices within Area 0 will temporarily lose adjacency with each other.
- C. Some traffic from Area 1 to other areas will no longer follow the lowest cost path.
- D. Switch-1 and Switch-2 will adjust the cost with which they advertise area 1 traffic in the backbone.
Answer: C
NEW QUESTION 64
Refer to the exhibit.
The company wants the fastest convergence and best load sharing of traffic over the links between Switch-1 and the VSF fabric. Which technology should the network administrator implement on these links?
- A. LACP
- B. loop protection
- C. MSTP
- D. RPVST+
Answer: A
NEW QUESTION 65
Refer to the exhibit.
Switch-1 and Switch-2 are AOS-Switches, which are iBGP peers. ISP 1 and ISP 2 advertise some routes to the same Internet destinations. Switch-1 and Switch-2 must select between these routes based on AS path length.
What is required for Switch-1 and Switch-2?
- A. iBGP synchronization enabled
- B. eBGP and iBGP administrative distance set to the same value
- C. Multihop enabled for the connection to the iBGP neighbor
- D. ECMP disabled for BGP
Answer: B
NEW QUESTION 66
Refer to the exhibits.
Exhibit 1
Exhibit 2
Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?
- A. Due to changes at ISP 1, Switch-1 now selects a different best route.
- B. An administrator has applied a route map on Switch-1 that filters advertised routes.
- C. Due to changes in the private network, Switch-1 can no longer reach 192.168.2.1.
- D. Switch-1 can no longer reach ISP 1 at 192.168.1.1.
Answer: A
NEW QUESTION 67
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator needs to understand why endpoints that use Switch-3 as their default router can no longer reach some resources. The exhibit shows the OSPF link state database (LSDB) on Switch-1 when the OSPF solution was first deployed and the current LSDB.
What is a likely place to find the issue?
- A. in the Switch-1 OSPF Area 1 configuration settings
- B. in the connectivity status between Switch-1 and Switch-2
- C. in the Switch-3 OSPF Area 1 configuration settings
- D. in the connectivity status between Switch-3 and Switch-1
Answer: B
NEW QUESTION 68
Refer to the exhibit.
A network administrator needs to deploy AOS-Switches that implement port-based tunneled node. Their Aruba controller has IP address 10.1.10.5/24. The architect has assigned tunneled-node endpoints to VLAN 20.
What is one issue with the current configuration planned for VLAN 20 on the switch?
- A. VLAN 20 cannot have an IP address.
- B. VLAN 20 must have GRE enabled on it.
- C. VLAN 20 must have an IP address in the same subnet as the controller.
- D. VLAN 20 must not enable jumbo frames.
Answer: D
NEW QUESTION 69
Refer to the exhibit.
The network administrator enables DHCP snooping globally and on VLAN 2. An additional step is mandatory for DHCP snooping to operate correctly and for clients to receive DHCP settings.
What is the additional mandatory step?
- A. Define an authorized DHCP server.
- B. Define edge ports as untrusted DHCP ports.
- C. Enable ARP protection.
- D. Define trk1 as a trusted DHCP port.
Answer: B
NEW QUESTION 70
Refer to the exhibit.
A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the company's requirements?
- A. The proposed switches should be replaced with switches that support VSF to support the required distance between stack members.
- B. The proposed switches should be replaced with switches such as the Aruba 2930M to support the backplane stacking technology.
- C. VRRP should be implemented instead of backplane stacking to support the Layer 3 redundancy requirements.
- D. Link aggregations should be established without LACP to support the Layer 2 redundancy requirements and backplane stacking limitations.
Answer: D
NEW QUESTION 71
A network administrator needs to set up an AOS-Switch to use port-based tunneled node for connected devices. However, the administrator wants the switch to forward traffic without tunneling if it cannot reach a tunneled-node server.
What should the administrator do?
- A. Configure a local switching profile on the Mobility Controller that acts as tunneled-node server.
- B. Set the switch to role-based tunneled node, and make sure it uses the default initial user role.
- C. Make sure that the switch has an IP address on the untagged VLAN assigned to the ports.
- D. Apply the tunneled-node profile to ports, and set the local-switching-fallback option.
Answer: B
NEW QUESTION 72
Which switches can be deployed in a mesh topology for backplane stacking?
- A. Aruba 3810 switches
- B. Aruba 2920 switches
- C. Aruba 2930M switches
- D. Aruba 2930F switches
Answer: A
NEW QUESTION 73
A network administrator can set the OSPF metric type on an AOS-Switch to Type 1 or Type 2. What is the difference?
- A. A Type 2 metric assigns cost to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.
- B. A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.
- C. A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.
- D. A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.
Answer: C
NEW QUESTION 74
Refer to the exhibits.
Exhibit 1
Exhibit 2
A company has attempted to implement OSPF without success. The devices in Area 1 need to be able to reach Area 2. Routes should be aggregated for advertisement in other areas. What must be changed to meet these requirements?
- A. Move the 10.1.0.0/16 range to Area 2 on Switch-1 and the 10.2.0.0/16 range to Area 1 on Switch-2.
- B. Add Area 1 and Area 2 on VLAN 100 on both Switch-1 and Switch-2. Remove Area 3.
- C. Add the 10.2.0.0/16 range on Switch-1 and the 10.1.0.0/16 range on Switch-2.
- D. Change Area 3 to Area 0; remove Area 1 from Switch-2 and Area 2 from Switch-1.
Answer: D
NEW QUESTION 75
Refer to the exhibit.
Switch-1 runs BGP. What should the network administrator do to permit Switch-1 to establish a neighbor relationship with Router-1?
- A. Set the BGP AS number to 46501.
- B. Enable BGP on VLAN 100.
- C. Specify 192.168.1.0/30 with the network command in the BGP context.
- D. Configure 192.168.1.2 as a neighbor manually within the BGP context.
Answer: D
NEW QUESTION 76
What is a reason to create a virtual link between two OSPF routers?
- A. to permit an OSPF adjacency between two VSF fabrics
- B. to create a connection between two areas that are not directly connected to Area 0
- C. to monitor connectivity with the neighbor, but not exchange the routing table
- D. to permit OSPF to operate between two routers that also run VRRP
Answer: B
NEW QUESTION 77
A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on branch switches.
What should be set up for this purpose?
- A. an RMON alarm
- B. an SNMP trap
- C. an IP SLA profile
- D. an auto-config server
Answer: B
NEW QUESTION 78
Exhibit
In the exhibits, VLAN 20 under a device name indicates that device is configured with that VLAN.
The exhibits also indicate whether VLAN 20 is statically configured on each link, either as an untagged or a tagged VLAN. If the link has no label, VLAN 20 is not statically configured on that link.
A network administrator needs to deploy AOS-Switches that use port-based tunneled node.
The plan calls for tunneled-node endpoints to be assigned to VLAN 20 and for the Aruba Mobility Controller to handle the tunneled-node traffic at Layer 2. Which exhibit shows the correct plan for VLAN 20 in the wired infrastructure?
- A. B
- B. D
- C. A
- D. C
Answer: D
NEW QUESTION 79
......
Accurate & Verified Answers As Seen in the Real Exam here: https://www.latestcram.com/HPE6-A45-exam-cram-questions.html
